video1.0<iframe src="https://www.loom.com/embed/42adf7873e5f403da801fdff3ff4500f" frameborder="0" width="1280" height="960" webkitallowfullscreen mozallowfullscreen allowfullscreen></iframe>9601280Loomhttps://www.loom.com9601280https://cdn.loom.com/sessions/thumbnails/42adf7873e5f403da801fdff3ff4500f-09c54dc7feff55bb.gif422.766667Step 1: Capture Pole Angle Critical for accuracy - must be done correctly 1. Position the accuracy stick against the pole 2. Hold the flat back of your phone against the top target on the stick 3. In the app, tap "Capture Angle" 4. Keep phone positioned and tap again when prompted 5. Remove phone from pole, then place it back on the target 6. The app will count down 3 seconds and take a second measurement 7. Verify both measurements match 8. Tap "Continue to Next Step" Step 2: Take Measurement Photos AI-guided positioning for maximum accuracy Taking Photos: 1. Hold down the camera button (don't just tap) 2. Use the bubble level at the top of the screen: ○Tilt your phone until the bubble is centered and turns green ○The AI determines the exact angle needed based on your position 3. When the bubble is green and centered: ○Screen will flash green ○Photo is automatically captured 4. Release the button to reset 5. Move to different positions and repeat as needed 6. Keep auto-capture ON (highly recommended for accuracy) Step 3: Calibrate the Image AI-assisted target detection 1. Tap "Search for Circles" 2. The AI will automatically locate the two targets on your accuracy stick 3. If AI finds both targets: Calibration is complete automatically 4. If AI misses targets or finds wrong objects: ○Tap incorrect circles to deselect them ○Tap "Add Manual Point" ○Drag the point to the center of the missed target ○Repeat for second target if needed Alignment Check: ●Use the arrow buttons to tilt the measurement line ●Ensure the line is perfectly straight with the pole ●This corrects for any stick placement issues Step 4: Set Pole Boundaries Final measurement setup 1. Set Bottom of Pole: ○Zoom in if needed ○Drag the bottom marker to the actual base of the pole (not the measurement stick) 2. Set Top of Pole: ○Drag the top marker to the highest point of the pole 3. Verify Measurement: ○Check the displayed measurement (e.g., "7 foot 2 inches") ○View from other photo angles if available 4. Tap "Next Step" when satisfied Step 5: Finalize 1. Tap "Finalize" (attachment options are typically disabled) 2. Wait for "Syncing" indicator at top left 3. Process complete!