video1.0<iframe src="https://www.loom.com/embed/f4c4e5ff98c94c5f81da54854a9cfed4" frameborder="0" width="1920" height="1440" webkitallowfullscreen mozallowfullscreen allowfullscreen></iframe>14401920Loomhttps://www.loom.com14401920https://cdn.loom.com/sessions/thumbnails/f4c4e5ff98c94c5f81da54854a9cfed4-559f721d1d214327.gif87.020267This Loom explains how to properly adjust the arm lock tension on an EAVJ150. First, it warns against forcing the arm lock handle closed because it can damage the bolt, arm, or rod. To correct the tension, tighten the shaft using a 6mm wrench by a couple of turns, then test by pulling and reading the four gauge in newtons set to peak; zero the gauge before measuring. It targets 75 plus or minus 5 newtons, and the example pull shown reads 80, which falls within the acceptable range.